SAVING YOUR STONES On the Sunnen CK type honing head, the stones are a one shot install. We all have that box of good single stones though, and various ways to reuse them. I take a single strand of copper wire and lay it in the “teeth” of the stone holder and then...
MAKING IT SIMPLE When I build my bobweights a simple piece of PVC for a stand makes it easier. Just zero out the scale and add the weight. Randy Torvinen Torvinen’s Machine Menahga, MN August, 2020
OHC LIFTER PULLER When I disassemble an Ecotec head I always have trouble getting the lifters out. There is not enough room for my small fingers to grab on and sometimes they are stuck with varnish. I use ¼” fuel hose, about a 6” length, to slip over the tip of the...
TONING UP AN LS On LS Crankshaft’s we are balancing, I always use a tone ring alignment tool to check that the alignment is correct. Then we place two equally spaced welds to ensure the ring stays aligned. High RPM LS engines have been known to spin the tone ring....
BLASTING OBSERVATIONS Here’s a couple of tips regarding soda blasting. Soda is very fine and it can become very cloudy and difficult to observe your work. I have drilled fresh air intake holes around the periphery of the viewing window, which helps keep the area...
LIMITING OVERSPRAY ON THE SMALL STUFF You can buy a premade spray booth or you can set up a makeshift paint booth using a cardboard box on its side. For extensive spraying you can cut a hole in the box and connect an exhaust fan to remove overspray. If using a larger...