MARKED FOR REPEATABILITY I always mark the flywheel when I’m done balancing so the customer will install it in the exact same spot as where I balanced it. I always shift it full right on the slop in the mounting bolts, opposite crankshaft rotation. Testing with a...
DIAGNOSING THE CHICKEN AND THE EGG Sometimes a failure or even a comeback seem obvious and we point a finger at a failure point and assume that it was defective. A little investigating might show a cause and effect scenario and what might be thought of as defective or...
I AM DZUS Dzus fasteners come in various sizes, and slot radii. Although tools are available for R&R, many people use screwdrivers which do not engage fully, can slip, gouge paint and damage the finish. They also do not have enough leverage for stubborn fasteners....
VALVE GUIDE SIZE GUIDES I have an assortment of common valve guide sizes that are precision honed on the I.D. that I use for quickly setting up the valve guide dial bore gauge. It takes much less time than using the fixture and you can easily add or subtract from them...
TRANSFER PUNCHES I use a set of machinist Transfer Punches to help me set up on an existing hole that may have a broken bolt or even broken drill bit, that is below the surface. The Transfer Punch is designed to drop into a hole by specific size, and the center punch...
RTV REMOVAL TOOL If you have ever had to clean RTV off of a gasketless oil pan, timing cover or other parts, you know how hard and time consuming this task can be. We have found that running a round ball end Allen wrench, where the ball fits the groove in those parts,...