RATCHET REPAIR When my ratchets get noisy or sluggish I soak the head in 90wt. gear lube overnight and drain them the next day. The ratchets work like new. I find that 90wt gear lube lasts longer than engine oil and gives smoother operation. Will Samples S&S Imports...

QUICK INSTALL TOOL Yes it's great to have the proper tools to install a press-fit pick-up tube onto your new oil pump. There are times when you may be helping someone in their shop and you need to improvise a quick tool to get this job done. With two simple cuts with...

INEXPENSIVE T-HANDLE BOLTS For 7/16” holes, take a 7/16” rocker arm stud, weld a metal pin at 90¨ on end and it becomes a T-Handle. Make 2 of them, this way you don’t need a wrench to take a lift chain off of an engine block. For ½” bolt holes you can do the same, but...

TRANSFER PUNCHES I use a set of machinist Transfer Punches to help me set up on an existing hole that may have a broken bolt or even broken drill bit, that is below the surface. The Transfer Punch is designed to drop into a hole by specific size, and the center punch...

I AM DZUS Dzus fasteners come in various sizes, and slot radii. Although tools are available for R&R, many people use screwdrivers which do not engage fully, can slip, gouge paint and damage the finish. They also do not have enough leverage for stubborn fasteners....

SET SCREW LOCK DOWN To repair a set of heads that had been threaded and tapped for screw in studs, and where we could not use a shouldered hex stud or guides plates, I locked the studs in with set screws. Whoever had worked on these heads before had tapped the heads...