BROWSE BY CATEGORY
BROWSE ALL SHOP SOLUTIONS
DIAL BORE GAUGE HOLDER
DIAL BORE GAUGE HOLDER Boring Bar Stands don’t have any place for holding your dial bore gauge. I bought a magnetic spay gun holder from a paint and body shop supply store. I stuck it on my stand as you can see in the picture and now that gauge is right where I want...
TAPERED ROD PIN BUSHINGS
TAPERED ROD PIN BUSHINGS Pin Bushings require about the same amount of interference fit as a piston pin. The same rod heater you use to fit pins can be useful with certain pin bushings. Tapered rods can be very difficult to remove and install bushings in and usually...
SMALL DIAMETER DAMPERS
SMALL DIAMETER DAMPERS It is a common practice to use the early Chevrolet V8 6-1/8” diameter harmonic damper as a light weight performance upgrade to the 6-3/4” and the 8” dampers that come on the later, longer stroke engines. Though no horsepower is to be had by...
POLISHING ARBOR
POLISHING ARBOR I made an arbor to polish piston pins and pilot bushings that can be chucked up in my lathe, or even in a drill chuck. First I cut off the head of a long carriage bolt. This one was 3/8” coarse and will fit in a small drill chuck. Then added a nut,...
BMW UNDER PRESSURE
BMW UNDER PRESSURE One of the most difficult heads to pressure test is the BMW DOHC 6 cylinder. It is nearly impossible to plug the water outlet on the side of the head, until now. A “T handle drain plug” from a boat is the perfect size, and easy to install and...
MAKING THE SEAL ON WET HEADBOLTS & STUDS
MAKING THE SEAL ON WET HEADBOLTS & STUDS 40 to 50% of our business is hi-performance boat engines, and the head bolt/stud sealing is critical on these engines. Jet boats use “waste” water from the jet pump to cool the engine and the pressure applied to the water...
