BROWSE BY CATEGORY
BROWSE ALL SHOP SOLUTIONS
CLEAN CUT
CLEAN CUT When surfacing blocks or heads, it’s a good idea to deburr all the water jacket and bolt holes before making cuts. Many heads have scale and residue on those areas that can cause “drag” marks when the tool bit passes over. Marine heads, or any head that’s...
STRAIGHTENING WITH STUDS
STRAIGHTENING WITH STUDS Smaller crankshafts and camshafts are so “springy” they can resist straightening and can be hard to straighten by peening. I prefer to use a peening technique on all the crankshafts and camshafts that come through the shop. When on the...
FALSE SEAT I.D.
FALSE SEAT I.D. When trying to determine if an iron head has a false seat ring in, we have found the fastest method is to mag-check the head. If it has a false seat in it, you will know instantly. Adney Brown Performance Crankshaft Ferndale, MI MAY,2022
CLEARLY CURTAINS
CLEARLY CURTAINS Due to a recent addition of shop equipment, all our machines were moved to make room. To help keep close or neighboring machines from getting each other dirty from flying debris, I used an inexpensive shower liner as a wall between them. Hung with a...
BEFORE COVID AND BEYOND
BEFORE COVID AND BEYOND Way before the Covid virus I was concerned with getting infection by customary handshaking. I was cutting or scraping my hands on a regular basis in the shop. To keep any germs from entering my body I used the “newskin” liquid bandage to seal...
REMOVING PIPS
REMOVING PIPS Often when parting off a work piece in the lathe, the tool may leave a "pip" or thin ring attached to the work piece....even when using a right-hand cut-out insert or blade tip. Here's an easy, quick way to remove the unwanted "pip" or thin material:...
