BROWSE BY CATEGORY
BROWSE ALL SHOP SOLUTIONS
VALVE CLEANING
VALVE CLEANING Take a valve guide liner (K-Liner or other) of the appropriate stem diameter and insert into drill press chuck. This will provide a nice protected grip on the valves while they’re spinning. Have a pan of solvent underneath and grip the head of valve...
GEN 5 GM LT THRUST BEARING UPGRADE
GEN 5 GM LT THRUST BEARING UPGRADE The new Gen 5 GM direct injected V-8's only come with a half thrust bearing in the main bearing set. The GM coated bearings are a very nice bearing if a Bi-Metal Aluminum bearing is ok for the application. So far on the sets that...
EASY HEIGHT TRANSFER
EASY HEIGHT TRANSFER When setting up valve springs or checking valve spring pressure I set a spring retainer on my Height Mic and use that to check the springs on the tester. To figure the installed height, bring the tester to the desired pressure and open the Height...
MANDREL ORGANIZER
MANDREL ORGANIZER One day I was walking threw the shop and looked at my rod bench and noticed how all my mandrels were just lying on the bench disorganized and presented a bad look to customers who walk threw my shop. So I decided to fix that by going down to the...
TAPED FOR PROTECTION
TAPED FOR PROTECTION When working with a customer's brand new cylinder heads, I cover the finish machined ends with painters tape to avoid scratches during any finish procedures and assembly. When someone pays big money for a set of heads, the last thing they want to...
ANYWHERE INDICATOR
ANYWHERE INDICATOR My Linebore didn't have any indicators on the column and it's nice to know the amount you are moving the bar. I just siliconed magnets on the back of these small indicators for easy set-up. I use them on the LineBore and other Machines. Randy...
