BROWSE BY CATEGORY
BROWSE ALL SHOP SOLUTIONS
CARBIDE GROOVE CLEANER
CARBIDE GROOVE CLEANER I needed a narrow grooving tool to quickly clean carbon from piston ring grooves, for an engine restoration project. All the usual grooving tools were too wide, however a carbide tipped circular saw blade was a perfect fit. Using an angle...
INSTALLATION TOOL TOOL
INSTALLATION TOOL TOOL When installing a reluctor wheel on an LS crankshaft, using the brand name alignment tool, use a piece of 4.5" pipe, notched and with a bar welded on the back to take the hammer blows. I can avoid banging on the tool and this provides a better...
FILL IT TO THE TOP
FILL IT TO THE TOP If you have a piston with a dome volume, you're unsure of, here's an easy way to check. Wrap a single layer of thick packing tape around the head land, taller than the dome. It will maintain the full round shape if you're careful. Fill it to the tip...
RECYCLED MEASURING TOOL
RECYCLED MEASURING TOOL To install valve guides on my heads, I just make custom fit measuring tools out of the 6" steel rules I get at the trade shows. I cut them to fit in the lifter bores of the overhead cam engines. It's quick and simple. Matt Peebles Matts Machine...
QUICK EASY STRAP WRENCH
QUICK EASY STRAP WRENCH The diameter of a diesel engine oil filter was larger than my biggest filter wrench, so I made this strap wrench from an old spark plug socket, worn-out poly-V serpentine belt, and a short length of PVC 1/2" schedule 40 pipe. I used an angle...
IT’S HIP TO BE SQUARE
IT’S HIP TO BE SQUARE It's tough to end gap rings in a canted deck engine such as a 409 Chevy. Turn a scrap piece of cylinder sleeve to about .003’ smaller than the bore. Make sure it’s long enough. Use that and it will allow you to push the rings down the bore...
