BROWSE BY CATEGORY
BROWSE ALL SHOP SOLUTIONS
CAM BEARING INSTALLATION
CAM BEARING INSTALLATION Nothing worse than having to fit a camshaft after installing new cam bearings, because they are too tight. I dial-bore gauge check all cam bores of the “known offenders”. I also use a Sunnen Jr. Hone to hone cam bores to the correct size...
CRANK STROKE CHECK
CRANK STROKE CHECK I have a quick and easy way to check or measure the stroke of a crankshaft. I put the crank on some V-blocks on the vertical mill table. I chuck up a BB Chev fuel pump pushrod or any similar round stock in a drill chuck. Position the rod throw...
IT’S ALL BALL BEARINGS THESE DAYS
IT’S ALL BALL BEARINGS THESE DAYS When checking volume on large chambers or ports, I fill them with precision steel ball bearings. It requires less time to fill and less fluid. Simply calculate the volume of the ball you’re using and multiply by the number added. Add...
FUEL LINE CRACKS
FUEL LINE CRACKS When rebuilding large diesel engines like Caterpillars with high pressure fuel lines running along the blocks or heads, make sure to install all of the factory line clamps and hold downs back in the factory location. They are designed to hold these...
HOMEMADE HEAD BENCH
HOMEMADE HEAD BENCH I fabricated an easy to clean steel topped cylinder head bench. Wrapping over the edge allowed for drilling holes, then inserting adjustable pipe holders. I can easily position any passenger car or light truck head for various work performed, from...
ROD AND CAP CUTTING DONE RIGHT
ROD AND CAP CUTTING DONE RIGHT When cutting the parting faces on rods and caps for resizing, make sure the bearing locating tang is facing the same way for both on the cap grinder. This way, if the parting surface is not perfectly 90° from the side, cutting the cap...
