BROWSE BY CATEGORY
BROWSE ALL SHOP SOLUTIONS
T-TAPS
T-TAPS I have some pipe taps with a T-handle welded on we keep in the cleaning department. It's easy to clean the rust or sealer from oil galleys and block drains. You cannot make the holes deeper with these, and they don't walk away with the T-handle on them. Randy...
COAT-IT HANGER
COAT-IT HANGER If you coat head gaskets with copper coat spray, using a clothes hanger as a support is a convenient way to keep the spray off of your hands and to keep your gasket from sticking to another surface. Adam Cofer Don Ott Racing Engines York Springs, PA...
LOAD BLOCKS WITH EASE
LOAD BLOCKS WITH EASE I have an older thermal cleaning system by Peterson. The shot blaster is designed more for cylinder heads than blocks as it is a side loading machine. To wrestle blocks into the machine was not reasonable so I came up with this simple solution to...
LS PISTON PIN SIZE
LS PISTON PIN SIZE Stock GM LS full floating connecting rods use a .943" pin and stock LS press rods use a .945" pin. Some aftermarket forged pistons designed to use a stock LS 6.098" length rods come with the .945" pin type. Pistons can be used as "Pressed" or...
DIAMONDS AREN’T ALWAYS FOREVER
DIAMONDS AREN'T ALWAYS FOREVER When using my profilometer for bore and surface readings, I hold the drive on the workpiece until the stylus has retracted and recorded it's reading. Then, I lift it off and let it retract without touching the workpiece. This effectively...
A SIMPLE REMINDER
A SIMPLE REMINDER Even well-regarded brand name dial indicators typically have a +/- accuracy equal to 1X to 2X their resolution and can read +/- 0.0005" after 2 to 3+ revolutions. For example, a Mitutoyo 0.5" range, 0.0001" resolution indicator has a factory stated...
