by Donnie Hurt | Dec 9, 2025 | ASSEMBLY
This is a customer’s balancer, though the procedure will work on a new one with the rubber bonded outer ring. I make a groove that runs down to the center hub. I use a chisel or a cut-off wheel, then I take a pick with yellow paint and mark the line. Should this...
by Donnie Hurt | Oct 1, 2025 | TOOLING
To turn a small block Chevy crank with the damper on, I cut off an old crank snout and remove a few thousandths from the diameter so it would slide inside the damper. Than I can use it along with my crank-turning socket. Sylvain Tremblay Les Ateliers de Moteur...
