by Donnie Hurt | Oct 9, 2024 | TOOLING
Sometimes we need to use a dial bore gauge that is set-up directly off of a micrometer. It can be hard to center both ends of the bore gauge with micrometer’s anvils. Simply cut a small piece of 1/4″ rubber tubing and slip it on one side. The bore gauge...
by Donnie Hurt | Oct 8, 2024 | CYLINDER HEADS
When you’re grinding Titanium valves, if you want a super shiny finish, grind them with the green wheel and “Mirror finish”. Wipe them off before pulling them from the chuck and give them 30 seconds of spinning with a microfiber towel and some...
by Donnie Hurt | Oct 8, 2024 | BLOCK WORK
I was never a fan of tapping a 1/2″ hole for a 1/2″ pipe plug which measures about .530 diameter. I’ve been using 9/16-18 set screws for the SB Chevy street and race builds for years. A 9/16” starting tap will work without drilling, and I finish up...
by Donnie Hurt | Oct 8, 2024 | TOOLING
When working with different manufacturers of blocks, lifting bolt sizes can vary significantly. Our solution was to elongate the bolt holes of our lifting chain on the links towards the end, so that larger diameter bolts can slip through. We then have the thread size...
by Donnie Hurt | Oct 8, 2024 | OPERATIONS
With identity theft and fraud at an all-time high I try to be super mindful of what I throw out. Even handing a customer an old box with some of their parts in it. You never know what could be had or come of your name and address and etc. on a box. Pretty much all...
