by Donnie Hurt | May 1, 2019 | ASSEMBLY
FUEL LINE CRACKS When rebuilding large diesel engines like Caterpillars with high pressure fuel lines running along the blocks or heads, make sure to install all of the factory line clamps and hold downs back in the factory location. They are designed to hold these...
by Donnie Hurt | May 1, 2019 | CYLINDER HEADS
HOMEMADE HEAD BENCH I fabricated an easy to clean steel topped cylinder head bench. Wrapping over the edge allowed for drilling holes, then inserting adjustable pipe holders. I can easily position any passenger car or light truck head for various work performed, from...
by Donnie Hurt | Apr 1, 2019 | CRANKSHAFTS & CONNECTING RODS
ROD AND CAP CUTTING DONE RIGHT When cutting the parting faces on rods and caps for resizing, make sure the bearing locating tang is facing the same way for both on the cap grinder. This way, if the parting surface is not perfectly 90° from the side, cutting the cap...
by Donnie Hurt | Apr 1, 2019 | OTHER SHOP WORK
NUT CLAMP When you need to shorten or chamfer a bolt, it can be difficult to mount it in a lathe Chuck without boogering up the threads. An easy solution to this problem is to take a nut of the same size and pitch as your bolt and make a slot in it with a hacksaw or...
by Donnie Hurt | Apr 1, 2019 | OTHER SHOP WORK
TWISTED DOWEL PULLER Removing stubborn open dowels is easy with a spiral bolt extractor. Just give it a light tap, twist and gently pull up. The force is evenly distributed all the way around and most of the time, the dowel can be reused. Dave Matton D and D Auto...
